Directed 556UW UNIVERSAL REMOTE START INTERFACE W/ SELECTABLE WINDINGS

BRAND NEW

DIRECTED 556UW UNIVERSAL REMOTE START

INTERFACE W/ SELECTABLE WINDINGS

SELECTABLE KEY WINDINGS FOR PRECISION RF TUNING

THIS PRODUCT REQUIRES PROFESSIONAL INSTALLATION

UNIVERSAL REMOTE START INTERFACE

W/ SELECTABLE KEY WINDINGS: Working ignition key required for operation.

The 556UW remote start immobilizer interface module is used when

installing remote start products in vehicles equipped with a transponder or

RF (Radio Frequency) based immobilizer system. This type of system uses a small chip

imbedded in the ignition key, called a transponder, to transmit a very low powered RF signal.

This signal is picked up through an antenna (or coil) around the ignition switch which is then sent to

the immobilizer’s transceiver. Once the correct signal is received, the immobilizer will enable the

ignition and/or fuel systems. If an attempt is made to start the vehicle and the transceiver does not

receive a valid code, the ignition and sometimes the fuel systems are disabled.

The immobilizer system will then not allow the remote start to successfully start the vehicle.

The 556UW bypasses the immobilizer system only while the remote start is in use, maintaining the

factory system’s integrity. When the remote start system is not in use the factory immobilizer remains fully functional.

Notes:
Requires use of a spare key for the vehicle.
Replaces 555U, 555UW, 555B, 555BW

Selectable key windings provide ability to tune kit to specific transponder frequency

used by different manufacturers.
Simple jumper selection to tune kit for European vehicles (60 windings)

or domestic (18 windings)
Tamper prevention circuit provides ability to open keysense circuit to prevent immobilizer

module from reading two RFID's at once and going into tamper mode.

Keysense trigger provides ability to shut off universal transpondear bypass as soon as driver’s ignition

key is put into cylinder for key take over. This prevents the vehicle from detecting the 2nd RFID

of driver’s key and causing a tamper code. Works with any aftermarket remote start system.

Compatible with the factory anti-theft system

Maintains the integrity of the factory anti-theft system

Two, jumper selectable antenna ring settings.

Compact design, easy to mount.

No programming required

Maintains the integrity of the factory anti-theft system

6-PIN HARNESS

RED (+) 12 Volt Input: Connect this wire to a fused source of constant 12V.

BLUE (-) Status Input: Connect this wire to the remote start negative (-) status output.

PINK (+) Ignition Input: Connect this wire to the vehicle’s true ignition output.

BLACK (-) Chassis Ground Input: Connect this wire to the vehicle’s chassis ground.

VIOLET (+) Keysense Input: Connect this wire to the vehicle’s

positive keysense output wire.

GREEN (-) Keysense Input: Connect this wire to the vehicle’s negative keysense output wire.

3-PIN HARNESS

BLACK and BLACK/RED Wires: Both of these are antenna ring wires.

BLACK/WHITE: Refer to alternate wiring diagram.